Bauer P8TS No sound - repost

[banahdang@gmail.com]

Hi,

 

My Bauer P8TS has no sound but visual part is fine. Internal/External speaker stays in mute even I tried with paper strip to the optic sensor.

After disassemble the projector it turned out the fuse on bottom board (Si1) is gone. Tried to replace it but it keeps blown away.

 

When I asked in 'Teknik' section before(my original post has been deleted now. Assuming category matter, I am sorry for the mistake..) somebody suggested to check if C37/38 is damaged. But based on what I am seeing from the service manual, I can't find C37 or 38.

 

Is there anyone could give me a tip or some suspect point that I need to inspect?

[jacquestati]

Typically, the big capacitator that is located behind the 4 diodes (Graetz-circuit) is short circuited and may have killed at least one of the diodes. You must check and replace it. To get there remove the base plate and the circuit board, unsolder the parts...

[banahdang@gmail.com]

10 minutes ago, jacquestati said:

Typically, the big capacitator that is located behind the 4 diodes (Graetz-circuit) is short circuited and may have killed at least one of the diodes. You must check and replace it. To get there remove the base plate and the circuit board, unsolder the parts...

 

Dear jacquestati,

 

Thank you for the advice. I will check that first and would do feedback. Hope it works!!

[makrofotografie]

I was somebody 🤓

 

 

[banahdang@gmail.com]

10 minutes ago, makrofotografie said:

I was somebody 🤓

 

 

 

Thank you very much. I appreciate it!

I've tested C37,38,32,40,9 (mainly big Caps), it turned out C37 is shorted. Now I have ordered the parts, so hope this can sort it out.

 

With all respects thanks again for your quick advice and I'll get back here as soon as replacing C37. 

[jacquestati]

...you're welcome!

[banahdang@gmail.com]

On 8/18/2020 at 9:57 PM, jacquestati said:

...you're welcome!

 

On 8/18/2020 at 9:37 PM, makrofotografie said:

I was somebody 🤓

 

 

Hey I swapped C37 with new Cap, same 63v 1000uF but 40-125'C instead 40-105'C.

It works! Fantastic! Now I can make the experiment with optic sound. Thousand gratitudes!

[makrofotografie]

🥰🥰🥰

[jacquestati]

Congratulations!💪